The mickey mouse $12 20-in-1 usb adapters wired to the transmitter are a joke, I don't need pirated software. Operating Systems: Windows, LINUX and MACįor a number of years, I've been looking for an interface that I could use with my transmitters and receivers. Operating Voltage: 3.8.V - 6.0V (typical 5.0V) USB2SYS interface emulation (to connect BEASTX flybarless devices).for neXt - CGM rc Flight Simulator, Heli-X, FMS, aerofly and others Phoenix R/C Pro Simulator, Real Flight R/C Flight Simulator, REFLEX XTR) Compatible with most RC flight simulators (i.e.
#Realflight 7 code by techsupport serial#
So the device is future-proof in respect to additions like emerging serial signal receiver protocols. The RX2SIM firmware is user upgradeable with the BEASTX StudioX application. RX2SIM converts the incoming control signals into a trainer signal that can be used by the simulator interface dongle.Īlso you can use RX2SIM as wireless joystick (gaming device) to control any computer program that uses a joystick interface.Įspecially this allows to control RC Simulators that do not supply any special usb interface dongle like "neXt - CGM RC Flight Simulator" or most shareware simulators. You can use a conventional receiver with standard servo output ports as well as common serial signal/singleline receivers (supported protocols are PPM, Futaba S.Bus, SRXL, Spektrum DSM2/DSMX, JR DMSS). The control signals are transmitted from the receiver to RX2SIM via the supplied patch cable (included in box). RX2SIM connects your RC receiver with the simulator dongle. There is no need for a trainer port on the radio anymore. It can be used in combination with most radio control systems.Īll you need is a transmitter and receiver that has sufficient number of channels for your application. RX2SIM allows to convert nearly any RC simulator on the marked to work wireless. No more short and annoying cables between your computer and RC transmitter.